Knights Electrocom

A 3/8 thread quick release bayonet adapter.

Fits between the antenna and mount to allow quick removal of the antenna.

Available in standard (middle), large (right) or short heavy duty (left), as in the picture.  The short version has 2 bayonets rather than 1 on the others.

Note: currently only the large version (on the right of picture) is available.

A 3/8 fitting spring, to fit between an antenna and mount.

Gives rigid antenna some degree of flexibility.

The light duty is very weak and possibly only suits antennas up to about 2ft.

A VERY heavy duty 3/8 thread spring - for use with heavy antennas such as Firestik & 1/4 wave whips.

• Length:  10cm
• Diameter at centre:  4.5cm
• Diameter at ends:  3cm
• Fitting:  3/8 thread

A 3/8 thread swivel adapter.

Used to adjust the angle of an antenna - often used when fitting an antenna onto a vertical surface (eg back of a cab).

The adapter is tightened and adjusted using the supplied alan key.

A fold-over adapter for use with 3/8 thread antennas.

Allows you to easly fold your antenna down for going in garages, car parks, low bridges etc.

Just pull up on the sprung-loaded casing and the antenna then easily folds over.

Adapter to fit on a SO239 mount to convert it to accept a 3/8 thread antenna.

Also see below for our 3/8 adapter with swivel (for the same price!)

Made by Sirio to fit on their SO239 mounts (either magnetic or body) to convert them to accept a 3/8 thread antenna.

When fitted on the matching mag mount, you can not even see there is an adapter there!

An adapter to allow you to use a 3/8 thread antenna on a SO239 mount.

This adapter includes an adjustable swivel - allowing you to angle the antenna up to 90 degrees.

We have also seen this adapter used to plug a mobile antenna directly into the back of a radio!  But whether you will ever swr it is another question??

An adapter to allow you to fit a DV type antenna onto a SO239 mount.

Special discount if you can find a use for 10 or more of these!!

A radial kit to fit any standard 3/8 antenna.

Simply screw this into your 3/8 base, then screw your antenna into the top of this - and then you have a mobile antenna with 3 radials!

Solder-on plug to fit on the bottom of DV type mounts.

These do need a small soldering iron and a steady hand!   If in doubt buy a made up lead.

Wing-nut and bolt to fit a standard DV mount.

Adapter to allow you to fit a standard 3/8 thread antenna onto a DV mount.

Adapter to allow you to fit a DV type antenna onto a 3/8 mount.

Can also be used together with the 3/8 to DV adapter (C52) to make up a "swivel".

An adapter to fit on the mount which is often found factory fitted on Volvo trucks, to convert it into a standard 3/8 thread mount.